The filter plate running slowly in filter press

Date:2018-09-17From:DZ filter press

The filter press has the advantages of good solid-liquid separation effect, wide adaptability, especially for the separation of viscous materials. 
Filter plate is an important part of the filter press, it is often encountered in the work of damage, slow and so on. The filter plate problems would affect the normal operation of filter press. So, the maintenance of the filter plate is very important. The problem of filter plate running slowly can also enable us to better maintain the normal work of the filter plate, then how to solve this question about the filter plate speed running slow?
First: The plate-frame Filter Plate have been appear this kind of situation, may be because of the guide rod oil stains, excessive stains, so that the guide rod and contact parts of the friction is too large, the hydraulic pressure of the fuel tank has become abnormal. We should promptly clean up the grease on the guide rods, stains, and timely coated with the right amount of butter, to ensure that its lubrication in general to deal with these similar problems, especially one important point is strictly prohibited in the guide rod to daub dilute oil, because the oil is easy to make the plate-frame filter press bottom is very slippery, It is easily to fall down when the staff operation overhaul, so it must pay more attention.
Second: For the plate-frame filter press whether there is a squeeze or obstruction of the situation, be sure to check in time! Because it would be particularly affected the plate-frame filter press speed once the squeeze or obstruction, it can not be ignored. Therefore, regular inspection, appropriate stretching and cleaning of the circuit is also very important link, only in this way to make the oil circuit unblocked. 
From the above introduction, we can see that the filter plate movement slowed down is likely because the parts of cleaning is not in place caused, so in the maintenance process of equipment not only to meticulous cleaning parts corners, also should do double check to confirm the correct later to run again finally, so as not to cause greater failure.
Prev Article:Characteristics of Belts of Belt Press Machine
Next Article:The reason why the belt filter press has less mud

  • +86 18903999962